Windows 10: Stop Codes for Approx. One Week

I have been having Stop Codes for approx one week. They aren't always the same. I also had one occasion where the computer screen just went blank as if the computer was powered off.


Today I disconnected all external hard drives and non os hard drives and restored the computer, deleting even personal files on the SSD.


I am currently only installing software as I need it.


Within the last hour I received a Stop Code again. I have three photos of stop codes I as able to catch.


It has been quite a while since I have had to troubleshoot so I am a bit rusty.


Here is my system information:


OS Name Microsoft Windows 10 Pro
Version 10.0.18363 Build 18363
Other OS Description Not Available
OS Manufacturer Microsoft Corporation
System Name DESKTOP-#######
System Manufacturer ASUS
System Model All Series
System Type x64-based PC
System SKU All
Processor IntelR CoreTM i7-5820K CPU @ 3.30GHz, 3301 Mhz, 6 Cores, 12 Logical Processors
BIOS Version/Date American Megatrends Inc. 0603, 9/2/2014
SMBIOS Version 2.8
Embedded Controller Version 255.255
BIOS Mode UEFI
BaseBoard Manufacturer ASUSTeK COMPUTER INC.
BaseBoard Product RAMPAGE V EXTREME
BaseBoard Version Rev 1.xx
Platform Role Desktop
Secure Boot State On
PCR7 Configuration Binding Not Possible
Windows Directory C:\WINDOWS
System Directory C:\WINDOWS\system32
Boot Device \Device\HarddiskVolume6
Locale United States
Hardware Abstraction Layer Version = "10.0.18362.752"
User Name DESKTOP-#######
Time Zone Pacific Daylight Time
Installed Physical Memory RAM 32.0 GB
Total Physical Memory 31.9 GB
Available Physical Memory 27.5 GB
Total Virtual Memory 36.9 GB
Available Virtual Memory 31.0 GB
Page File Space 5.00 GB
Page File C:\pagefile.sys
Kernel DMA Protection Off
Virtualization-based security Not enabled
Device Encryption Support Reasons for failed automatic device encryption: TPM is not usable, PCR7 binding is not supported, Hardware Security Test Interface failed and device is not Modern Standby, Un-allowed DMA capable bus/devices detected, TPM is not usable
Hyper-V - VM Monitor Mode Extensions Yes
Hyper-V - Second Level Address Translation Extensions Yes
Hyper-V - Virtualization Enabled in Firmware No
Hyper-V - Data Execution Protection Yes

Many thanks for any guidance.

:)

 

Stop Code - apc mismatch

Hello,

Follow the steps listed by
Reymichael Ros

 

Weeks later...

Hi guys,

The crashing had stopped for approx. 2 weeks.
It has begun crashing again. I have a second hdd with Ubuntu on it and it has frozen sometimes, i then had to restart the computer manually.
Would it be correct to think that it most likely is an issue with my RAM sticks?

I have just changed the RAM slots i had my RAM sticks in.
I will run memtest86 many times over the next few days.

Any suggestions in my approach to this is greatly appreciated!

 

stop code

Hi,

Conflicts with the hardware driver is one of hte possible reasons why you are having a blue screen error with stop code, NTFS.sys. For us to assist you better, kindly answer the following questions:

• Have you made any changes to your computer prior to this issue?
• What troubleshooting steps have you done so far?
• Which Version and OS Build number of Windows 10 is currently installed? To check, press the
  Windows key, type winver, and press the
  Enter key.
• Can you provide us the complete stop code message?

Meanwhile, you can try the troubleshooting steps on this
link to resolve blue screen issues.

We will be looking forward to your response.