Windows 10: Stuck in boot loop after update and factory data reset what to do?

After an update my pc got stuck in a boot loop but before looking into it I just reset the whole thing and deleted all my files and it’s still stuck in a boot loop what should I do ? I’ve bought a new graphics card and ram and that didn’t solve anything

:)

 

Stuck In Set Up Loop After Factory Reset

Thanks, I can look at that now I'm on a laptop. Here was the screen tapping F11:





and this was the system before restoring it:

 

Stuck In Set Up Loop After Factory Reset

Product: Pavillion 550-103na
Operating System: Microsoft Windows 10 (64-Bit)

So after having an absolute nightmare not being allowed to factory reset, I finally managed to get it to do it by selecting only drives with Windows installed instead of all drives. It seemed to reset OK. But it got worse, now I start the PC, it gets the black screen and the HP logo, it then goes to a blue screen asking for location, click next, it says error and needs an update, click next to connect to WiFi as instructed and it restarts itself and loops back to the first screen asking for location. I don't have an external drive or anything, what can I do to get this set up again? It was bought in 2107 but barely used, it's practically brand new from lack of use so I just don't understand the problem.

 

Stuck on a reset loop after factory reset

I factory reset my hp envy because i was selling it and it was doing the automatic update but was closed at 64% so it didnt finish but now it is stuck in a loop where the hp logo will show for a while then itll go to yhe update screen showing the 64% then
the screen goes black and starts the process over. I believe it was downloading the windows 10 update. Any ideas?