Windows 10: Sudden BSOD on the device

Hello.I'm starting to have some issues on my device since a month ago. All started with a sudden BSOD after playing a game on my computer high-end game on low-end laptop. It was strange, but I thought it was a RAM usage, as most of BSOD I had was the same case. Then in a couple of hours I had the same BSOD. Then in the next hour, in the next 30 minutes, then it was on the point the device didn't booted up. I ran the RAMtest86 or something like that I had this installed on the computer because it came along with an Linux distro I downloaded and everything went well, I did it for like 5 hour

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

IRQ memory BSODS, device manager, memory range?

The only time I've seen that type of BSOD for myself is when I fried the PCI-e slots on my Striker 2 board... There wasn't anything that I could do, try and rma and go on.. I would suggest the steps that MilkyWay has said.. But, if you really don't know much about Bios's... I wouldn't play with Irq's... That can mess up everything on your board. USB, ethernet, ram, chip... But, that's just me on playing with irq's... To much of a hassle IMHO..

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast: