Windows 10: System restore point

Last night I had activated a system restore point in hopes to restoring my old data but that was far from what had happened. I left it on over night to make sure it had enough time to run and it was on the same screen, I shut down the pc turned it back on and was brought to a blue screen given the options of continue, use another operating system, trouble shooting, or turn off your pc. I’ve tried all these options and none work they all bring me to the same outcome of involving me restarting my pc then after that all of them will say your pc did not restart properly. Same with all the options

:)

 

System Restore Point Questions

Thanks, Dave!

Suppose I go back to an earlier version of C: with the desired restore point, restore from it and create a restore point on D:, then reload the current C:. Will I be able to restore from that restore point on D:?

Step by step:

1. Enable Restore for D:
   
2. Back up the C: drive with Acronis.
   
3. Restore C: to an earlier date with the desired restore point, from the Acronis backup image.
   
4. Restore the system from the desired restore point.
   
5. See if Restore is still enabled for D:. If not, enable it there, with the same capacity as in step 1.
   
6. Disable Restore for C:.
   
7. Create a restore point. Since there's no availability on C:, it should be created on D:, and be identical to the desired restore point.
   
8. Now put C: back to the current version using the backup created in step 2.
   

Will the system now recognize that restore point on D: and let me restore from it?

(Edited to add the explanation, and step 4.)

 

How to delete inactive System Image Restore Points in System Restore

Windows 10 64-bit.
When I click "show more restore points" in System Restore I see a bunch of old "system image restore points" that were deleted in past and do not correspond to any currently active restore points. Clicking any of these old restore points, I simply get an error message saying they could not be found, and to select another restore point instead.I would like to delete these restore points listings but have been unable to do so.
So far, I have tried steps mentioned below without any luck :

Disk Cleanup through (C Properties
Disable System Protection (OFF and ON) in System Protection for OS (C
Disk Space Usage to minimum (slider button all the way to the left then 'Delete all restore points for this drive'),
Delete all shown Restore points in CCleaner (the problem ones do not show here),
Reset Windows Backup to Default in Windows 10 with 'Reset_Windows_Backup.bat' utility.

Any suggestions highly welcome.

 

Cannot Create System Restore Point Because Cannot Turn On System Protection

In Control Panel/System/System Properties/System Protection, "Available Drives," all that is listed is "Searching..." No drives are located, so no System Restore point can be established.

How to fix?

I have an extensive active thread in another area of the community dealing with the failure of this PC to install the latest Windows 10 update. Prior to executing the next suggested step to fix that problem I need to create a System Restore point, so a
solution to this issue must be found before I can move forward on the major problem.

YES, I have ALREADY run the SFC Command as Administrator and the report was that everything was A-OK.