Windows 10: Taskmanager doesnt show what is used by the Network

Hi, Since I got a new PC my Taskmanager shows how much network is used at all, but not how much is used by the Task. I even filtered by Network descending so that the highest usage should be on top. My motherboard does have two ethernet ports MSI ACE x570. One Intel with max 1 Gbit/s and one Realtek with 2.5 Gbit/s. If my cable is in the Realtek Port it works completely normal but in the Intel port it does like in the screeenshot below.


My Question is not important because i just use the Realtek Port but i would like to know why this is the case?



:)

 

ms store and taskmanager

Hi,

I would like to know if you're still having this issue with MS Store and Taskmanager. In line with this, kindly provide the following information:

• What is the error message when running MS Store and Taskmanager?
• Were there any changes made before this issue came up?
• What is the build and version of your Windows 10? To find out which version of Windows your PC is running, press Windows logo key + R, type
  winver, then select OK.
• What are the troubleshooting steps you have done so far?

I'm looking forward to your response.

 

Laptop won't show list of available networks

We suggest checking the list of available Wi-Fi networks on your laptop.

Please follow these steps:

• Click the Windows logo.
• Go to Settings (gear icon).
• Select Network and Internet.
• Then Wi-Fi.
• Make sure the Wi-Fi radio button is On.
• Select Show available networks, then you'll be able to see the list of available Wi-Fi networks.

Update us with the outcome so we provide further assistance.

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.