Windows 10: test traffic with iperf3 windows 10 occur blue screen error

hello all when I was developing the network card driver for windows 10, when I used iperf3 to test traffic, it ran for about 5 hours, and a blue screen appeared. There was a problem when calling the NdisMAllocateNetBufferSGList api. stack******************************************************************************* ** Bugcheck Analysis ** **************************

:)

 

Blue screen error - SYSTEM_SERVICE_EXCEPTION

Hi,

Blue screen errors usually occur due to system file corruption and outdated drivers. For us to provide an effective solution, we would need you to answer the following questions:

• Which build of Windows 10 is currently installed on your computer?
• What changes have you made to the device before you encountered these errors?

In the meantime, we suggest performing the steps available in this link. It serves as a guide on how
to troubleshoot blue screen errors in Windows 10.

We're looking forward to your response.

 

Error. Blue Screen

Hi,

In addition to the above mentioned solutions by Community members, I would like to add the following:

Before we proceed I would like you to answer the following question:

• 
  What is the make and model of your computer?
  
• 
  Did you make any changes prior to the issue?
  

The issue might occur due to Viruses, or something changing/deleting in Registry Files, a failure during Bootup, or a corrupt file which could be due to age of a computer or viruses or somebody tampering with files.

I suggest you to follow the step below:

Step

I suggest you to refer the article below and check if it helps:

Troubleshoot blue screen errors

http://windows.microsoft.com/en-us/windows-10/troubleshoot-blue-screen-errors

Please get back to us with updated status, we will be happy to assist you.

 

Why blue screen error occurs only when I close my explorer?

Hi Guys,

For past one month , I am experiencing very strange blue screen error which pops up only when I close my explorer before shut-down, normally it occurs while closing heavily opened tabs (When I have around 10 + tab opened in explorer) I am using Torch explorer.

When this blue screen occurs the system scans for 4 to 7 seconds and then it itself restarts.

It has been seen that when I close the explorer after I close each individual tab then this blue screen error does not occurs.

Recently I also formatted my SSD and reloaded windows 7, but still yesterday I faced same problem within 4 hours of fresh install.

Processor:i7 3770k

Motherboard:Asus P8Z&&-V Deluxe


My system specs are in my profile.