Windows 10: the cr4 register value does not change after pae is disabled in windows7_32

i used bcdedit -pae ForceDisabled to diasble pae, after I reboot the machine the bcdedit mark of pae is already ForceDisable but i uesd livekd and kd to check the cr4the pae mark is still be 1CR4 value has never been changedIs pae unable to be turned off or is CR4 displaying an error?my windows7_32 is a xen hvm

:)

 

PCI register value is changed

PCI register value which was set mm command has changed some case

If value was 0...7 is ok,

But, In case of value over 8, It becames plus 10

8 -> 18

9 -> 19

a -> 1a

.....

It occurred version 1904 2004

Any clue about this?

I checked it in another OS(Linux)

so, I don't think thin is hardware problem

 

Can't change value for Diagnostic and usage data

We would like to know more about this concern, kindly answer the following:

• May we know the build of the computer?
• Any changes on the computer prior to this concern?
• Aside from the suggested troubleshooting steps on this thread, what troubleshooting steps have you tried so far?

We will be waiting for your response.

 

RBE voltage register hacking

From the values of your registers, it seems likely that you can change your voltages. Try increasing voltages in little steps and watch your temperatures very carefully.
Registers 0x15 to 0x18 simply denote the address of the values in the chip. Usually I would have denoted them 0 to 3 or 1 to 4, but since the 0x15 to 0x18 notation has become popular during the research for the RivaTuner method... *Roll Eyes