Windows 10: The IO operation at logical block address...failed due to a hardware error

Hi:As of last week I have been getting error 154's similar to the above. I also get regular 153 warnings as well. This has resulted in failed boots, regular chkdsks on boot up freeze ups and corrupted applications. I have reset the system once and the problem has returned. I have run an exhaustive diagnostic on the hybrid drive and it passes. System File Checks are mostly clean, but occasionally need to repair.Is there anything anyone can suggest I can do to pinpoint if this is a hardware issue affecting the disk subsystem?AMD processor on Gigabyte motherboardSeagate FireCudaWin 10 build

:)

 

The IO operation at logical block address....was retired.

Hi thanks for the reply.
Here is the link to the results Microsoft OneDrive - Access files anywhere. Create docs with free Office Online. .




Iv'e only done up to point 9 atm

 

The IO operation at logical block address 0x0 for Disk 2 (PDO name: \Device\000000c8) failed due to a hardware error.

Hello, up until a few weeks ago my email and Seagate external hard drive were working well.

I figured out the problem with email after hours, but I cannot figure out how to get my hard drive back. It actually shows the device, but it's no longer connected to a drive letter, which it always did automatically.

I cannot express how frustrated I am that I have some sort of issue EVERY time an update is performed with Windows 10.

I have (2) Seagate hard drives, one shows up fine and the other disappeared from Explorer. Any advice would be helpful. This is the error that I found.

The IO operation at logical block address 0x0 for Disk 2 (PDO name: \Device\000000c8) failed due to a hardware error.

 

ever since moving to windows 10 I get The IO operation and logical block address error

This error is all over my event logs

The IO operation at logical block address 0x325d6d640 for Disk 2 (PDO name: \Device\00000054) was retried.

The IO operation at logical block address 0x322e90458 for Disk 2 (PDO name: \Device\00000054) was retried.

The system failed to flush data to the transaction log. Corruption may occur in VolumeId: M:, DeviceName: \Device\HarddiskVolume2.

(The I/O device reported an I/O error.)
The IO operation at logical block address 0x5f1790 for Disk 2 (PDO name: \Device\00000054) was retried.

this only hass occured under windows 10.

prior to upgrading to windows 10 edu. I was runing windows 7 ent and never had any errors like this

I have recently(last week) did a clean install of windows 10 ENT LTSB. and the errors are still there

this drive is pointing to an array on my areca arc 1261 ML controller, the logging for the controller shows no errors for itslef or the cache module, nor does the smart information for all of the drives in the array

the volume is 16x2tb drives in raid 6