Windows 10: The IO operation at logical block address for Disk 3 failed due to a hardware error but...

Hi everyone. Recently I started to receive a Disk Write Error in Steam during installation. After investigating the error, I ended up checking the Event Viewer and seeing this error. I tried running chkdsk with /r/f and also with /spotfix and it fixed something, but it seems to not have fixed the error. When I check CrystalDiskInfo I see the following The disk with problems is the one selected since it has the number 3 in disk management. The health is good, I also tried to run other tools to check it but no one of them showed error. I am aware that formatting the disk from zero, without quic

:)

 

The IO operation at logical block address....was retired.

Hi thanks for the reply.
Here is the link to the results Microsoft OneDrive - Access files anywhere. Create docs with free Office Online. .




Iv'e only done up to point 9 atm

 

The IO operation at logical block address 0x0 for Disk 2 (PDO name: \Device\000000c8) failed due to a hardware error.

Hello, up until a few weeks ago my email and Seagate external hard drive were working well.

I figured out the problem with email after hours, but I cannot figure out how to get my hard drive back. It actually shows the device, but it's no longer connected to a drive letter, which it always did automatically.

I cannot express how frustrated I am that I have some sort of issue EVERY time an update is performed with Windows 10.

I have (2) Seagate hard drives, one shows up fine and the other disappeared from Explorer. Any advice would be helpful. This is the error that I found.

The IO operation at logical block address 0x0 for Disk 2 (PDO name: \Device\000000c8) failed due to a hardware error.

 

ever since moving to windows 10 I get The IO operation and logical block address error

This error is all over my event logs

The IO operation at logical block address 0x325d6d640 for Disk 2 (PDO name: \Device\00000054) was retried.

The IO operation at logical block address 0x322e90458 for Disk 2 (PDO name: \Device\00000054) was retried.

The system failed to flush data to the transaction log. Corruption may occur in VolumeId: M:, DeviceName: \Device\HarddiskVolume2.

(The I/O device reported an I/O error.)
The IO operation at logical block address 0x5f1790 for Disk 2 (PDO name: \Device\00000054) was retried.

this only hass occured under windows 10.

prior to upgrading to windows 10 edu. I was runing windows 7 ent and never had any errors like this

I have recently(last week) did a clean install of windows 10 ENT LTSB. and the errors are still there

this drive is pointing to an array on my areca arc 1261 ML controller, the logging for the controller shows no errors for itslef or the cache module, nor does the smart information for all of the drives in the array

the volume is 16x2tb drives in raid 6