Windows 10: The system crashes from time to time

PAGE_FAULT_IN_NONPAGED_AREA 50Invalid system memory was referenced. This cannot be protected by try-except.Typically the address is just plain bad or it is pointing at freed memory.Arguments:Arg1: ffffcc1e465d9ff0, memory referenced.Arg2: 0000000000000000, X64: bit 0 set if the fault was due to a not-present PTE. bit 1 is set if the fault was due to a write, clear if a read. bit 3 is set if the processor decided the fault was due to a corrupted PTE. bit 4 is set if the fault was due to attempted execute of a no-execute PTE. - ARM64: bit 1 is set if the fault was

:)

 

all games crash!

I suggest you run rthdribl > http://www.daionet.gr.jp/~masa/archives/rthdribl_1_2.zip
Increase the window size step by step and watch your vga temps permanently.
What happens?
If it crashes, run at stock speeds as suggested before and retry.

P.S.: When your system locks, does the display signal turn off after a time?
Stuttering sound or no sound at all when freezing?
What X1800XT model do you own exactly?

 

Can't able to change the system time

Hi,

If the system time is not changing after configuring the date and time settings on Control Panel, most likely, the BIOS clock is also incorrect. We suggest making sure that the date and time settings on your computer is properly configured. To configure
the date and time settings, follow the steps below:

• In Cortana search, type control panel.
• Choose Control Panel from the list.
• Select Clock, Language, and Region.
• Click Date and Time.
• Click Change date and time, then set the correct information.
• Click Change time zone, then select the correct time zone.
• Click Apply and then click OK.

If the system time still didn't change, we recommend that you contact the computer manufacturer for further assistance on how to check and configure the BIOS clock of your device.

Feel free to post back if you have other concerns.

 

Changing Time Format

Hi Mary,

There's a possibility that the set up time format in your computer Basic Input/Output System (BIOS) is military time. To have this checked, you can try to reset the time of your computer through Control Panel. See the steps below on how to do
so:

• Open Control Panel > Clock, Language, and Region >
  Change date, time, or number formats. This would open the
  Region window.
• From there, click on Additional settings at the bottom part. It will open the Customize Format.
• Click Reset; then, OK.

The steps should work; however, if not, we suggest that you contact manufacturer and have the BIOS time checked.

Let us know what happens after doing the suggestions .