Windows 10: The thread attempted to read from or write to a virtual address to which it does not have...

Every time I try to open a game in my PC, it crashes. When I read the crashlogs of the game it says The thread attempted to read from or write to a virtual address to which it does not have proper access. I tried about every solution but I didn't find any help. pls help.

:)

 

"The thread tried to read from or write to a virtual address for which it does not have the appropriate access."

Hi. I've recently downloaded a mod for a game and now whenever I try to open a save file, it just suddenly closes the game. I checked the dump files and it said "The thread tried to read from or write to a virtual address for which it does not have the
appropriate access." I've watched multiple tutorials online but all tell me to disable my antivirus and/or uninstall and re-install the application. Would that really be the correct way to fix this?

 

Slow HDD read and write speeds

Hi,

Thank you for writing to Microsoft Community Forums.

We will require a few more information from you to help you further with the issue. Please reply with the following details:

• In which device are you facing this issue?
  
• Are you using an external HDD or internal HDD?
  
• Are you getting the read and write speed issue on any particular application?
  

However, you can Disk Defragment on your computer to optimize the drive. To run Disk Defragment please follow the steps from the article

Defragment your Windows 10 PC.

Alternatively, you can check for the read and write speed of the HDD in task manager. Please follow the steps mentioned below to check the read and write speed of the hard drive:

1. Press Ctrl + Shift + Esc key together on the keyboard.
   
2. Click on Performance tab.
   
3. Click on Disk 0.
   
4. You will find the Read speed and
   Write speed at the bottom of the window.
   

Hope it helps.

Please reply with the status of the issue, we will be glad to help you further.

Nikhar Khare

Microsoft Community - Moderator

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!