Windows 10: Today I reinstalled the windows and I got a bsod. I verified it with WinDbg and said that...

https://1drv.ms/u/s!AkEoKAZbUj8qgcVegwAiFu5M4D2P9g?e=V9LTPw

:)

 

Driver Verifier BSOD on Start Up DRIVER_VERIFIER_DETECTED_VIOLATION

OK I'm going to keep this thread updated as I go through troubleshooting this issue.

As I have received no help with my minidumps, I am going through the process of learning to do it myself.

This seems
like a good guide to learn the very basics.

What has happened so far:

• New computer build, unstable windows install, slowly degrades to where the computer is unusable. Happens on multiple clean installs.

• Continuous error and critical messages in Event Viewer, some events of note are:
  • Event 219 Kernel-PnP, failed to load driver
  • Event 7031 service control manager (dozens on start up)

• First crash will happen on start up and it eventually degrades with below events.
  • Event 5 kernel general
  • Event 2 kernel-event-tracing
  • Event 3 kernel-event-tracing
  • Event 29 kernel-boot

• Tested hardware - no faults found

• Ran Driver Verifier and Windows will keep crashing with DRIVER_VERIFIER_DETECTED_VIOLATION until Driver Verifier is reset in safe mode

• Started this thread, PC became too unstable and had to do a system restore, restore had minimal changes (see above)
• Have not installed the applications and drivers removed after system restore.
• PC is heading down same road again, BSOD now appearing on startup.
• Ran Driver Verifier again - same resuslts
• Installed WinDBG to start analyzing new dumps from crashes that have been happening on startup.
  • dump 1 - pool_corruption
  • dump 2 - memory_corruption
  • dump 3 - memory_corruption
  • dump 4 - ntkrnlmp.exe

From the limited knowledge I got from the guide the only information I can get from WinDBG is shown above.

So that's where I am at the moment. My next step is to run Driver Verifier again and see what I can find.

 

BSOD error || Error : KMODE_EXCEPTION_NOT_HANDLED

That's odd. WinDbg says it's there...hmmm. I guess next step is to run Verifier as ZZ Suggested.

 

Install and Configure WinDBG for BSOD Analysis  


Please explain....stuck on step #2.......Windows 10 Forums what should be copied and pasted now that the above does not work and how do you check the progress?