Windows 10: Top feed on printer Canon Pixma mx472 won't work

how to get top feed working

:)

 

Canon Pixma Printer

Welcome to the club! In your case, you only need two steps:

1- Ask AT&T "Did you give me a modem only, or did you give me a modem and a router combination?"

If you got a modem/router combination, aka gateway:

2- Dig out the user manual for the PIXMA, where it shows you how to connect the printer to your network. My PIXMA user manual explains this in detail.

If all you got from AT&T is a modem, then your printer problems were not caused by the modem.

In that case, check out the technical support page for your PIXMA on Canon's website. It has lots of troubleshooting information and a way to contact Canon if you're ready to throw in the towel.

 

Canon Pixma Printer

Did you receive only a modem - or was it a modem combined with a router? The latter is known as a 'gateway.'

A modem's only job is to connect you to the internet. That wouldn't have anything to do with your printer.

The router is what establishes your network. If you got a gateway - which includes a router - then all you need to do is to re-connect the PIXMA to your network. Follow the same steps you followed when you set up the PIXMA for the first time.

AT&T wouldn't do it for you because your printer isn't their responsibility. But, no worries! Dig out your PIXMA user guide - or find it on Canon's website - and setup the printer just like you did the first time.

 

Unable to setup Canon MX472 in Windows 10

I have Canon MX472 unable to set up with Windows 10

***Post moved by the moderator to the appropriate forum category.***