Windows 10: transfer error 0x00000000

I'm trying to transfer some photos trought USB cable from phone and receiving this error full of 0's what to do?

:)

 

STOP error after Windows MCE 2005 clean install

OK, found the rest of it.

A problem has been detected and Windows has been shut down to prevent damage to your computer.

If this is the first time you've seen Stop error screen, restart your computer. If this screen appears again, follow these steps:

Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check your hard drive and make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.

Technical information:

*** STOP: 0X0000007B (0xF7C7B524, 0XC0000034, 0X00000000, 0X00000000)

 

UnattendedJoin error: failed to find the domain data (0x6e)

Thanks for the suggestion! I don't want to add a domain account, as this is a generic unattended install that will be used for all company machines. Do you think it's possible that the computer would join the domain if, instead of using UnattendedJoin in specialize, I used your steps but left out the specific account?

The other thing I was thinking was to use a generic account to allow the domain join during the specialize step. I added a machine password in the UnattendedJoin component, and instead of getting the error listed above, I got an authentication error, which makes me think I could probably do a secure join instead of the unsecure join.

Thoughts?

 

Error: No work available to process

Hmm. Either it's put out errors and WCG is limiting the work units available, or the project list may not be set to supply other WU when one runs out. (if the problem lies here and not on your end)

On the options to your left, if you go into Results Status, select the computer from Device Name and then look through results see if either they were returned late, errors or any other kind of issue that would stop the servers supplying WU from that perspective.

If there are no errors then it's maybe down to your project list. So selecting Device Manager from the left menu and then clicking on the profile assigned to that computer and make sure that it's assigned to receive WU for other projects if they run out.

At least those steps will rule out problems from the WCG end.