Windows 10: Trying to fix the windows update {KB5034441} but after few steps, I wasn't able to enable...

I'm trying to update Windows and it keeps on having errors about updating and telling me to try again later, but that update was in January 2024. So I followed a tutorial on YouTube to fix the update. Everything went well except for the last part, which I cannot enable the reagentc, and it says "REAGENTC.EXE: The Windows RE image was not found." I was in a panic because I wasn't sure how to fix it. I tried fixing it but they say I need to install the install.wim, but that doesn't exist because I have no idea where my DVD Disk is. I tried C:\Windows\System32\Recovery but the only thing in recov

:)

 

Stuck at Last Step for KB5028997 while troubleshooting Windows update (KB5034441) Error (0x80070643)

Hello Jonathan,

Thank you for your response however, the issue is not about installing windows update KB5034441 but the issue is realated to steps mentioned on KB5028997.

As you can see from the screenshot, I have followed all steps as mentioned on KB5028997 but I AM ATUCK AT THE LAST STEP which is command:

reagentc /enable.

After running the command "reagentc /enable" I get the message "The Windows RE image was not found".

Whereas before starting these steps, I checked that my "reagentc" was in enabled condition.

I hope now you are able to understand the issue and would be able to suggest steps to fix this.

Regards,

 

Intel Readies P55 Chipset B3 Stepping Update

Intel's is readying a hardware update for its P55 Express chipset, currently the only core-logic for the company's brand new socket LGA-1156 processor platform. The new B3 stepping of the P55 PCH will bring with it a little more than new MM number and S-spec numbers. A list of changes is as follows:

• New MM number and S-spec numbers for the converted products;
• Firmware and minor BIOS updates are required with the conversion;
• Processor MRC/microcode update required to enable future processors;
• Recommended storage driver upgrade from Intel MSM 8.9 to Intel RST 9.5.

Although it is listed that the MRC update enables 'future processors', Intel, in a statement issued to X-bit labs assured that the current B2 stepping of the chipset (found on current socket LGA-1156 motherboards) does not leave out support for any of Intel's new LGA-1156 processors that are slated for release in the very near future. The dual-core "Clarkale" 32 nm processor will be supported by both B2 and B3 steppings of the chipset.

P55 B3 stepping is pin-identical to P55 B2, and hence motherboard vendors will not have to come up with new designs. Sampling of the new stepping began as early as on October 02, 2009, and it is scheduled for shipment to manufacturers by the 7th of December, 2009. P55 is the performance core-logic for the LGA-1156 platform. It supports Core i5 and Core i7 "Lynnfield" processors with discrete graphics.

Source: X-bit labs

 

FIXED!! Windows 7 sp1 never ends searching for updates

Ok I did another reboot, disabled windows update service, did step 3 again, this time it installed an update, enabled windows update service and did a reboot and voila!! *Peace eace: