Windows 10: Trying to install Windows 11 from official USB, but it doesn't appear as a bootable device...

Hi all, So I've built the Entry Level AMD build on Pcpartpicker: https://uk.pcpartpicker.com/guide/pTgXsY/entry-level-amd-gaming-build I've got Windows 11 on an official USB stick but when I try and install it I get the error that 'This PC can't run Windows 11'. I think the problem might be that CSM is enabled and secure boot is disabled on the BIOS by default. However, when I disable CSM/ Enable Fast Boot I then can't see the USB with Windows 11 as a bootable device and the installation doesn't run, I only get the BIOS screen again.

:)

 

Multi-bootable USB

Hey guys from TPU, couldn't find any specific thread pertaining to the question asked on title. As mentioned, I'm trying to create a bootable USB, but with many specifics boots available.

I've been trying to create one with multiple boot device including one that enables me to run Windows 10 directly on the USB Thumb Drive but to no avail.

The list of bootable images i'm trying to create are

1. Windows 10 (A full OS running from thumb drive)
2. Windows 10 ISO (Bootable disk image for fresh install)
3. MemTest86+

Have tried YUMI or UUI from the website USB PenDrive Linux but as this is my first time, i don't know how am i screwing up or am doing it right.. Anyone got a rough idea on a step by step guide? Thanks!

 

Create Windows 11 Bootable USB on Mac with M1 Chip

One thing to note. You need to check the USB drive is functioning well and make sure that Windows 11 iso file you downloaded is from Microsoft website. An damaged Windows ISO file could also cause the USB to not be recognized as a bootable device.



If there is no problem with USB and ISO file, then go with UUByte ISO Editor instead. The above suggestions are free so you can try them first. UUByte ISO Editor is a free trial software but you can get a Windows 11 bootable USB installer in less than 20 minutes. From my past experience, UUByte ISO Editor is even better than Bootcamp and UNetbootin. It has no limitations, just 3 clicks (download, launch and burn) to get a bootable USB drive on your Mac.



Step-by-step tutorial for refernece: Make Windows 10 Bootable USB on macOS Big Sur in 3 Simple Ways

 

my 3Dprinter doesn´t appear

My 3D printer doesn´t appear on when I open 3D builder on the left popup to choose printer.

Is it need to do any previous step?? I thought It was plug and play. the printer is an UP Plus2 from Tiertime so, it is one of the recommended partners manufaturers. any message of error just doesnçt possible to send the prin.