Windows 10: Two issues after computer formatting

hii I have a problem after I formatted the computer

Sorry for my English


1. remote desktop protocol does not work for me

I can not connect through another computer to my computer before formatting it worked I have win 10 proIt gives me back error "The logon attempt failed"

2. When the computer is turned on the computer skips the BIOS and I do not see the screen of which buttons to press to enter the BIOS in addition I also press the button to enter the BIOS and it does not put me in either

In recovery I do not have the option of uefi so every time I want to enter the BIOS I have to remove the ssd on which the win is installed

How can I solve the problems I have please?

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Changing Time Format

Hi Mary,

There's a possibility that the set up time format in your computer Basic Input/Output System (BIOS) is military time. To have this checked, you can try to reset the time of your computer through Control Panel. See the steps below on how to do
so:

• Open Control Panel > Clock, Language, and Region >
  Change date, time, or number formats. This would open the
  Region window.
• From there, click on Additional settings at the bottom part. It will open the Customize Format.
• Click Reset; then, OK.

The steps should work; however, if not, we suggest that you contact manufacturer and have the BIOS time checked.

Let us know what happens after doing the suggestions .