Windows 10: two local disk D showing in disk management

I installed a new SSD to my laptop and then cloned my HDD to it then I used diskpart to delete partitions on HDD only leaving my local disk D which was partition 4 then I tried extend volume but it turned local disk D yellow which I want to convert back to blue and when I tried to extend volume again it actually extended my volume but it shows two local disk D on disk management and one in this pc.Help me get it fixed to normal.

:)

 

Local Disk D:

I continue to get messages telling me that my local disk D: is full. It asks me if I want to do a disk clean up. When I say yes, it takes me to disk clean up, but there is nothing showing that is on locak disk D:. It shows that I have plenty of space
and nothing gets deleted off of it.

What is actually stored on local disk D: and why am I getting this message if nothing is showing on it when I go to disk clean up?

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

Disk Management

Hi Keith,

Thanks for providing the detail that was requested previously. Since the disk management screen that you saw is showing greyed out options, we suggest that you follow the steps below to change the partition type of your internal drive:

• Open Disk Management then right click the partition on the disk you want to covert and select Delete Volume.
• Once you complete the process you will see the whole disk shown as two separate unallocated spaces. Right-click the disk and select Convert to GPT disk.

After the conversion, you will be able to use the whole disk and then you can create new separate partitions.

We look forward to your response to our queries.