Windows 10: Unable to connect to Ethernet and wifi

As I am writing this it has been 2 weeks and I have had this wifi connection issue. My pc which I run windows10 on was working perfectly fine until one day it could not connect to the Ethernet/wifi. I am honestly almost at my wits end, I’ve tried to troubleshoot the issue using countless methods, such as command prompts, driver updates/uninstall-reinstalls, network resets, forgetting the networks, loading into safe mode, and even factory resetting the pc. I just can’t seem to fix this issue, so in my last attempt I’m praying that someone can assist me in resolving this issue. Thank you.

:)

 

Bridging wifi and ethernet connections – wifi keeps disconnecting

Hi all,

I am trying to use Windows to bridge my wifi connection to non wifi devices. I have successfully setup the bridge in Network Connections. However, the wifi only stays connected for a few seconds before it disconnects (everything is working as expected, with wired devices having internet access, until wifi disconnects). This seems to be something to do with the ethernet cable being connected, as when I disconnect the ethernet the wifi stays connected.

Things I have tried:

• Turning off power management and checking bios for any funky power management settings
  
• Setting "Priority & VLAN" to disabled
  
• Disabling "Automatic metic" and setting wifi to priority order – though you don't seem to be able to change this for specific connections when bridged.
  

Any suggestions greatly appreciated.

P.S. everything works fine with bridge disabled and using internet connection sharing enabled on the wifi. However I am unable to connect to devices such as printers (hence why I am trying bridged mode).

 

Make Windows 10 connect/disconnect to WiFi based on Ethernet connection status

Steps:

1. Go to Control Panel\ All Control Panel Items\ Network and Sharing Center > click on 'Change adapter settings' then use the 'alt button' to show menus and select Advanced Settings...
   
2. Under Connections section, select Ethernet, and use the arrows to the right to move Ethernet above WiFi.
   
3. Click OK.
   

Windows will now prefer the Ethernet over the WiFi for connecting to the internet. This should apply for Windows 8, 8.1, and 10.

 

Windows 10 No Longer Connects to Ethernet and WiFi

This week brought Win10 ver 1903 and I can no longer get WiFi to connect if the ethernet cable is plugged in. If I boot with ethernet, manually trying to connect WiFi silently fails. If I boot without ethernet, WiFi is automatically connected yet drops
if I plug in the ethernet cable. Both the WiFi and the ethernet work fine by themselves, just not at the same time so I don't think it is a driver problem.

Any suggestions would be appreciated