Windows 10: Unable to enter Sysprep Audit Mode - Control + Shift + F3

Hi,

Trying to boot into Audit mode with a Lenovo X1 Yoga G2. I am at the screen where I am prompted with "Who's Going to use this PC". When I press Control + Shift + F3 the system volume goes up. This is Windows 10 Enterprise, Build\Version 1709. How can I get into Audit Mode off a brand new install?

:)

 

how to turn off audit mode

Hi Ben,


Thank you for posting your query on Microsoft Community.

Please try below steps to exit audit mode and check if it helps.

• 
  Press Windows + X, click on
  Command Prompt (Admin).
  
• 
  Enter following command and press
  Enter.
  
  sysprep /oobe /generalize
  

Note: Each time you run the sysprep command with the /generalize switch, the licensing state of the Windows is reset.

For more information refer the article below.

How Sysprep Works.

Hope this helps. Please reply if you need further assistance.

Thank you.

 

Can't enter Audit mode

hey guys.

Im building an unattended Windows 10 Pro setup following this guide: Customize Windows 10 Image in Audit Mode with Sysprep. Everything works perfectly altought I would like to improve the image with a few more pre-installed
softwares, so I started a clean setup using the previous build unattended Windows setup. The problem is that unlike before, it doesn't show the Settings dialog, after the first reboot it jumps straigh to the user setup, so there's no screen where ctrl + shift
+ F3 works.

Can someone guide about how to solve this issue?

Thanks!