Windows 10: Under Resources settings an error message ' This device isn´t using any resources because...

No error code:I developed a driver LINUX and Windows and the Verilog Code for the PCI Card and everything is ok when running on LINUX. In Windows I installed the driver and everything was ok about installation without any error code but Why the OS write zeroes to base address register BAR0 offset 0x10 and BAR1 offset 0x14 after booting?No memory mapped or interrupt set. Base Address BAR 0 0x00000001 and BAR 1 0x00000000 values.BAR 0 is an IO Address.BAR 1 is a memory-mapped address.

:)

 

your computer appears to be correctly configured, but the device or resource(web proxy) is not responding

Hi,

The error message "your computer appears to be correctly configured, but the device or resource(web proxy) is not responding" that you are getting, may have something to do with your profile or with the Windows components of your computer. With that said,
we will be performing some troubleshooting steps to isolate the cause of this problem. Before we proceed, kindly answer the following:

• When did you start experiencing this issue?
• What troubleshooting steps have you tried so far?
• Can you send us a screenshot of the error message? Make sure that you remove all personal information.

In the meantime, we suggest that you download the app troubleshooter on this
link and then run it on the computer.



Please post back with the result for further assistance.

 

'the remote device or resource wont accept connection'

Hello,

Refer suggestions mentioned in Answer here:

Redirecting

Hope this helps, Good luck

 

Printer isn´t working after latest update.

After the latest update from Windows, my Canon Pixma ip6600 printer isnt working. In Device Manager it shows up as working properly but when I go to print it isn´t listed as an option in any programs. Troubleshoot suggests it´s a USB 2 printer on a USB
3 port and that that´s the problem but that cant be since it worked fine before the update. I´ve tried to uninstall and plug it back in but that doesn´t work either.