Windows 10: Unsupported_Processor Error When Attempting to Enter Safe Mode or use a Boot USB

My Windows 11 installation is currently unable to properly load to desktop and I've been attempting to enter safe mode or run a Boot USB to reinstall the software but I'm instead receiving an UNSUPPORTED_PROCESSOR error with a QR code each time I attempt to boot into safemode or run a Boot USB.My computer is a an MSI Gaming Desktop Aegis RS 13NUF-4MSI, with an Intel Core i7 13th Gen 13700KF 3.40 GHz running Windows 11 Pro 64-bit.I would appreciate any assistance with getting the computer to either boot into safe mode or reformatting and reinstalling windows.

:)

 

Cannot Enter Safe Mode / Computer boots normally

I'm running Win 10 Pro 1903.

Here are the steps I have taken to get into safe mode: Start button, settings, update and security, recovery, advanced startup, troubleshoot, advanced options, startup settings, restart. The computer boots normally, not in safe mode. Any suggestions would be most helpful. Thanks in advance for your help and interest. .

 

BSOD at boot, can’t enter safe mode

Last night when attempting to boot my desktop I got a BSOD with the following stop code:

Page fault in nonpaged area
What failed: Ntfs.sys

I have attempted to boot into safe mode. During the boot process I make it to the “preparing automatic repair” loading screen, but then BSOD before it enters safe mode.

I have attempted to boot via a usb drive with Windows 10 installation media, but can’t get it to boot and I get the same BSOD. I entered BIOS and made sure the usb Drive was detected and selected it as the boot device. No change, still getting the message.

I have 2 sticks of 4gb RAM, which I suspected as a possible culprit based on google research. I removed them one at a time, booting each time, with no change to the BSOD.

I’m lost at this point and wondering if hardware is the problem, but I don’t know where to start. Any help is greatly appreciated.

Specs:
HP 580-023w
Windows 10
Intel i5-7400 cpu
8192mb DDR4/2400 MHz RAM
1 TB Toshiba Hard Drive

 

PC stuck in Safe mode, unable to boot to Normal mode.

Hi,

Thank you for posting on Microsoft Community. I understand the inconvenience you are facing. I will certainly help you with this.

I appreciate if you could answer few questions to narrow down the issue and to provide you better assistance.

• What error do you get when you try to boot in normal mode?
• Did you entered Safe mode through Windows Recovery Environment or through System Config?

I suggest you to try the below given steps and check if it works:

• Press Windows key + R and type msconfig and hit enter.
  
• On the General tab, tap or click the Normal Startup option.
• On the Boot tab, uncheck all the option under Safe mode.
• Tap or click OK, when you are prompted to restart the computer, tap or click Restart.

Please post back with the results and the information asked, we will be glad to assist you further.

Thank you.