Windows 10: update // linked to conversation

submitted by /u/cassandrlee
[link] [comments]

:)

 

Intel Readies P55 Chipset B3 Stepping Update

Intel's is readying a hardware update for its P55 Express chipset, currently the only core-logic for the company's brand new socket LGA-1156 processor platform. The new B3 stepping of the P55 PCH will bring with it a little more than new MM number and S-spec numbers. A list of changes is as follows:

• New MM number and S-spec numbers for the converted products;
• Firmware and minor BIOS updates are required with the conversion;
• Processor MRC/microcode update required to enable future processors;
• Recommended storage driver upgrade from Intel MSM 8.9 to Intel RST 9.5.

Although it is listed that the MRC update enables 'future processors', Intel, in a statement issued to X-bit labs assured that the current B2 stepping of the chipset (found on current socket LGA-1156 motherboards) does not leave out support for any of Intel's new LGA-1156 processors that are slated for release in the very near future. The dual-core "Clarkale" 32 nm processor will be supported by both B2 and B3 steppings of the chipset.

P55 B3 stepping is pin-identical to P55 B2, and hence motherboard vendors will not have to come up with new designs. Sampling of the new stepping began as early as on October 02, 2009, and it is scheduled for shipment to manufacturers by the 7th of December, 2009. P55 is the performance core-logic for the LGA-1156 platform. It supports Core i5 and Core i7 "Lynnfield" processors with discrete graphics.

Source: X-bit labs

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.


Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

Internet link is via a TP-link USB wireless connection. Link keeps stopping after conversion to Windows 10

Hi Roger,



Thank you for posting in Microsoft Community.

I regret the inconvenience caused to you. Let me help you.

• 
  Do you see any error code or error message on the screen?
  

I suggest you to perform the below methods and check if it helps.

Method 1:

Windows 10 has a built-in troubleshooter to check and fix issues with Internet connection. I would suggest you to run this troubleshooter to check if the issue is with your internet.

Refer these steps:

• 
  Press Windows key +X, select Control panel
  
• 
  Change the view by option on the top right to Large icons
  
• 
  Click on troubleshooting and click on the view all option on the left panel
  
• 
  Run the Internet Connection troubleshooter
  

Method 2:

Try updating the Network Adapter drivers from the manufacturer's website and check if the issue persists.

Follow the steps to update the Network Adapter drivers:

• 
  Press Windows key + X key and click Device Manager.
  
• 
  Expand Network Adapter.
  
• 
  Right-click on the Ethernet and click on Update driver software.
  
• 
  Restart the computer and check.
  

Check if it helps.

If the issue persists, download and install the latest network drivers from your computer manufacturer website and check if it resolves the issue.



I hope the issue will be resolved. If you have any further queries, please feel free to contact us again. We will be happy to assist you accordingly.



Thank you.