Windows 10: Update to Windows Insider Preview 20236 failing with error 0xC1900101-0x40017

I've tried to update several times my windows installation to Insiders Preview 20236.


However, installation rolls back after first reboot, with the following error code from SetupDiag


Error: SetupDiag reports rollback failure found.

Last Phase = Post First Boot

Last Operation = Ensure suspended services are stopped

Error = 0xC1900101-0x40017

LogEntry:


I've uninstalled all unsigned/third party drivers with pnputil and disabled all non-microsoft services clean boot, but setup keeps failing with the same error.

:)

 

Windows 10 Update Error 0xC1900101 - 0x40017

Hi,

Thank you for posting in Microsoft Community, we appreciate your interest in Windows 10.

I understand your concern with the error: 0xC1900101 - 0x40017 while upgrading to Windows 10, we will help you with this issue.

I would like to inform that this error may occur for one of the following reasons:

• Antivirus software conflicts
• Hardware conflicts
• Corrupted/ faulty driver conflicts

I suggest you to refer to the below article by Andre Da Costa, try the troubleshooting steps mentioned under:
0xC1900101 - 0x40017 error code and check if it helps.

How to: Troubleshoot common Setup and Stop Errors during Windows 10 Installation

Hope it helps. Reply to the post with an updated status of this issue for further assistance.

 

Error 0xC1900101- 0x40017

Hello,

You can refer suggestions mentioned and see if something helps you:

[FIX] Error "0xC1900101 - 0x40017'' ; Couldn't Update To Windows 8.1

Hope this helps, Good luck

 

0xC1900101-0x40017 The Installation failed in the SECOND_BOOT phase


Error with windows update, trying to install the November update of windows 10

0xC1900101-0x40017
The Installation failed in the SECOND_BOOT phase with an error during BOOT operation.

I have done the DISM stuff the SFC stuff and even did a full CLEAN install of windows 10 losing all my programs and that's how i got the error i listed above. I downloaded the patch using the Windows Media tool as the windows update wont seem to download it and say it will try again later. It always seems to fail on one of the restarts.

Any Idea how to get the November update installed? Oh and now some of my programs are saying im missing MSVCP100.dll and trying to go to the download page at Microsoft just says try again later.