Windows 10: USB 3.0

Hi I have a W10 and I have a problem with USB 3.0 that do not work at full speed but only partial as USB 2.0 The problem is not only on my PC but on all on which there are Win10. When I just tried to install Linuxy, the speed there is fine. They copy over 200mB/s to a USB 3.0 flash drive and 20mB/s in Win to the same flash drive. But I wonder why it has a problem with flash drives. If I connect an external USB 3.0 drive or hdd in a sata frame to a USB 3.0 port, the speed is fine so it's only a problem with flash drives but Linux doesn't have a problem with it so they're in the advisory. I don't know what to do with it. I tried to download all the drivers from the manufacturer for my MS board - but nothing helped and so I am already baffed. When I search for it on the net and try some drivers, either all the USB stops working or it ends in a blue death.



Dxdiag + photo

:)

 

USB 3.0 Question

That is the add in I have. I got it off the CM store. They also list an adapter, but I've yet to see it listed as in stock and can't seem to find any others.

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

Help with USB VID_0000&PID_0002\6&32FA202A&0&8

Hi Nikolaos,

We suggest that you apply the troubleshooting procedures below:

Method 1: Run Hardware Troubleshooter
to diagnose issue with hardware if there are any on your computer. Follow the steps:

• Click Start or press Windows logo and go to
  Settings
• Search for troubleshooting and select Troubleshooting
• Go to Hardware and Sounds
• Select Hardware and Devices and click on next, then follow the on-screen instructions.

Method 2: Disable and re-enable all the Universal Serial Bus controllers (USB) controllers.The USB controllers represent the USB ports in Device Manager.

To disable and re-enable the USB controllers, follow these steps:

• Open Device Manager
• Expand Universal Serial Bus controllers.
• Note: You might have to scroll down the list to find this item.
• Right-click the first USB controller under Universal Serial Bus controllers, and then click Uninstall to remove it.
• Repeat the above step for each USB controller that is listed under
  Universal Serial Bus controllers.
• Restart the computer. After the computer starts, Windows will automatically scan for hardware changes
• Reinstall all the USB controllers that you uninstalled

Let us know how it goes.