Windows 10: USB-C ethernet Adapater in disconnecting/reconnecting loop after startup

Hi, I use an ethernet adapater USB-C with my laptop, and i have a strange behavior that i can't fix.When i start my PC with the adapater already plugged-in, everything is fine during approximately 1min max. Then, the adapater disconnect for maybe 20sec and reconnect for 1min, then it's a loop, it does that until i unplug/replug it.After replugging it, the issue disappear.I tested deactivating EEE, "Allow computer to shut off this devices", any advanced parameters that could cause this problem, but so far i can't seem to fix this.The reference of the ethernet card used in this adapter is : Re

:)

 

usb keeps disconnecting and reconnecting windows 10

Hi,



Thank you for posting your query in Microsoft Community. I regret the inconvenience caused to you. Let me help you.

• 
  What is the make model of your system?
  

I suggest you to Change the USB power management settings and check.

• 
  Open Device Manager.
  
• 
  Double-click the type USB to change power management settings.
  
• 
  Right-click the specific device you want, and then click
  Properties.
  
• 
  On the Power Management tab, change the power management settings.
  

I would also suggest you to refer to the suggestion by
Ashish Sondhi from the following link and check if it helps.

Redirecting



Also refer:

• What if a wired device isn't installed properly?

Windows help & learning

(Note: steps in the above article applies to Windows 10 as well)



Let us know if you have any further query on Windows, we are glad to assist you.



Thank you.

 

USB devices disconnecting/reconnecting

I turned off Power Management but no luck. As for the Resources tab in Device Manager, it's not showing up for my network adapter. I tried reinstalling it and updating it but it's not showing up.

 

USB 3.0 randomly disconnecting and reconnecting, not power config

So I have a Surface Pro 3 running Windows 10, and an external USB 3 HDD. If I plug in the HDD, a process will begin. First the drive will appear with the drive letter only, and be unreadable, but in an unusual way. Any software that attempts to interact with it will hang until it either crashes or the drive is disconnected. During this stage the drive may disconnect and reconnect multiple times. If left in for long enough, the drive will finally show up with it's name, and be readable. However it still disconnects and reconnects.

Steps I have tried:

• Disabling the power saving features for all USB devices in Device Manager
  
• Reinstalling all USB drivers
  
• Testing hard disk on my desktop computer (where it works fine).
  
• Powering down the drive for an extended time before trying again