Windows 10: USB devices are overloading and turn off and on randomly and suddenly.

Hello everyone, Today I am writing about an issue with my USB devices I have been struggling with for a little while now. My USB devices will randomly disconnect and reconnect when I am using all of them at the same time. I am a streamer and I noticed when I stream and all of my USBs are on, sometimes they will all disconnect and reconnect very quickly. At first I thought it might be a power issue with my motherboard so I bought a poweredUSB 3.0 hub and plugged most of my usbs on it because it was separately powered, but that did not help so I ruled it was not power as an issue. The next thing

:)

 

USB device not recognized spam

Hi Kyle,

You may receive this error if one of your USB connected devices is not properly recognized by the system. Let's try the troubleshooting steps provided by
Krishna Prasobh V on this
thread.

In addition, we suggest that you turn off the notifications from the USB by following these steps:

• Open Settings by typing "settings" in Cortana's search box.
• Click on Devices.
• Locate USB and toggle the switch to Off.

Keep us updated with the status of your concern and we'll be glad to assist you further.

 

I don't have any bluetooth devices but windows turned it on!!


Then if they are still on, try some of these steps listed below, Not all of these steps may not apply, but, step #2 and #4 should help. I have all 4 steps on myself.

1 Go to Device manager and DISABLE Bluetooth, Do Not remove!
2 Turn USB suspend off
3 Set Hard Drive or SSD to Never
4 Turn Link State Power Management off
Settings 2 thur 4 can be found in your Power Management Settings.
Then click on "Change settings that are currently unavailable"
Then Reboot your Computer. This does work, may come back if you shut OFF your computer,then turn it back on, if it does, just a reboot will turn it off again.

 

unknown device USB

Hi Ali,

In most cases, this issue can be caused by either an unstable/ corrupt USB controller or your computer's drivers need to be updated.

For us to isolate the possibilities, we suggest that you perform the following troubleshooting steps in succeeding order:

• Connect your USB drive to a different port. Alternatively, try to connect it to a different PC.
• Connect a different USB drive to your PC.
• Unplug your USB drive and restart your system. Afterwards, plug it in and see if it works. If the same issue occurs, perform a complete shutdown and wait for a few minutes before turning it on again.
  
• Update your drivers.

If you find that the USB drive still doesn't work even after performing all these suggestions, this is most likely pointing to a hardware issue. Thus, it would be best to get in touch with your device manufacturer for a thorough check of the device.

If you have any other questions or concerns, feel free to post back and let us know.