Windows 10: Usb not Formatting After Live Booting Linux

installed a Linux live boot on my USB drive. After I finished using it, I booted back into Windows 10 To format the USB drive to try another operating system. I used DiskPart for this, but I encountered an error that I haven't been able to resolveif the image dose not Load this is the ErrorDiskPart has encountered an error: Access is denied. See the System Event Log for more information.

:)

 

No boot from USB

As Kyhi mentioned, If you're booting from a USB drive, it doesn't matter what you have on your laptop drive.
How are you pointing to boot from the USB drive, by BIOS priority or by boot menu during POST?
Follow these steps to open the Startup menu when the computer is powered off.

1. Turn on the computer.
2. Immediately press the Escape key repeatedly, about once every second, until the Startup Menu opens.
3. Select the EFI USB drive

PS.: You can only boot as UEFI if the OS is 64 bits. Is your Linux on the USB drive 64 bits version?
Is the USB drive formatted as Fat32?

 

USB boot for bios update

Did the first step. It already doesn't work. Note the capacities and drive letters M:/N: The HP utility is about to format my raid-1 volume containing my 2 750gb drives. It thinks it's the usb stick. I can not select any other drives in the HP utility. My 512mb usb stick is U:.

Any other suggestions?

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!