Windows 10: USB Not Recognised Problem

I have a problem with my wired mouse. Whenever I connect it to my CPU , a message will continually pop out saying"USB not recognized'. I tried to reconnect it, but it is still saying the same. Can anyone tell a fix for it.

:)

 

USB not recognised after years using it.

Thanks for your suggestion.
Uninstalling USB Device and booting up and reconnecting the Xpress USB flush drive did not work it was still not recognised on any of the 6 USB 2.0 or on any of the 7 ports on the USB 3.0 hub, although it is recognised on other pc. I am now transferring the data to another USB drive before I format the Xpress and see if it is recognised again in the original pc.

 

USB Memory Stick not recognized by Windows 10

I followed both steps suggested by Anish but still no joy. My laptop 'recognises' the usb by making a sound but fails to open it or even list it.

I'm using a Samsung series 9 laptop with Windows 10 and the USB is Maxwell 8gb.

I've used this same usb before in the same machine with no problems. The connection is obviously good as the red light in the usb comes on but it goes no further.

Hope you can help - there's some crucial stuff on the usb that I need to access.

thanks.

 

USB wireless mouse 'USB device not recognised'

Hi,

There are a lot of possible reason why this issue has occurred. We have some
questions for your to isolate this matter:

• 
  Have you tried using the USB mouse to other computer?
  
• 
  Is this happening with other devices?
  
• 
  What other troubleshooting steps have you done so far?
  

We suggest that you perform these methods of troubleshooting steps and check if there's any changes:

Method 1: Run the
Hardware and Devices Troubleshooter.

To run the
Troubleshooter,
follow these steps:

• 
  On the search bar, type
  Troubleshooting
  and hit
  Enter.
  
• 
  Choose
  Hardware and Sound.
  
• 
  Click on
  Hardware and Devices
  to run the troubleshooter
  

Method 2: Update your drivers.

To know how to update your drivers, click
here.

Method 3:
Run SFC Scan.  

To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Method 4:
Run DISM Tool.  

To run
DISM Tool, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    

NOTE:
This might take a while to finish scanning.
Do not cancel. 

Method 5: Clean Boot.

To perform a
Clean Boot, click
here.

Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.

If the issue persists, it is possible that the
device itself has issues. We suggest that you
contact the store
from where you
bought the device.

Let us know how it goes.

Regards