Windows 10: Using mobile internet when the cable is connected without internet

Hi,In my work, I need to constantly connect to various devices PLCs with a network cable. But at the same time, I need internet via mobile connection.But Win 11 interrupt the mobile connection when I insert the cable. How can I turn it off?

:)

 

HTC 7 Mozart mobile not connecting to internet

Hello,

If you cannot connect to Wi-Fi or use the Mobile Data on your HTC 7 Mozart device, we suggest that you follow the steps given on
Lumia troubleshooting and repair. After each step, check to see if your issue has been fixed.

• For issues connecting to Wi-Fi networks, select Connectivity > My phone has problems connecting to Wi-Fi networks, then follow the suggested steps provided.

• And for issues connecting to the internet using a mobile data connection, select
  Connectivity > I cannot connect to the internet using a mobile data connection. Make sure to select the next options given if the problem persists.
  

We're just here if you have further questions.

Regards.

 

I want to connect old cable to my new internet card

Yeah it`s coaxial network cable...
I must buy expensice PLANET VC-202 Converter VDSL2 1x BNC, 1x RJ-45




or install new internet connection (cable and receiver). Any suggestions?
I want to use radio internet connection. Is this possible to connect it to Realtek 8111B (10/100/1000 Mbit)?

 

Internet Connectivity Issues

So heres the deal. My brother who is behind the opposite wall of me is having internet issues. The router is here in my room and his internet is plugged into the Linksys E2000 via a wire going from it to an ethernet wall socket going to his room and into his computer.

He has been having iffy internet for the past 2 days. Fixed it yesterday by rebooting now the problem has resurfaced.

What we have tried:

• Testing the ethernet cables with a tester. Passed
• Tested onboard ethernet with known working cable (computer hooked up using my connections in my room) Passed
• Checked to make sure there was no static IP address in IPv4 settings. Passed
• Made sure the Network Connection wasnt full on disabled. Passed
• Swapped the cable leading from the router to the wall outlet in my room. Passed and worked for a few minutes.

With regards to that last bullet point, the computer is no longer getting internet again despite working for a few minutes. Testing the new cable again, tells us that pins 1 and 2 are "open". That is the second cable in a row that the tester is spitting this message out on.

Any ideas guys? Im out of them.