Windows 10: UX425EA Laptop unable to charge, or plug in to use on power

Recently did a BIOS update, I think while I was doing the update my battery drained and died while updating in progress. When I managed to reboot, I felt that the update had been disrupted but reflected the latest firmware version UX425EA.317. But I am no tech expert to check. Weeks down the road, I realized that my battery wasn't charging up/ slow charging until 0%. I thought it was the battery issue and had it changed for $160 but then the issue arose again. So I did some research on this issue and found out that I had a missing AC ADAPTOR DRIVER from my device manager. Now the repair shop t

:)

 

My Computer is Plugged in but not Charging

My laptop computer is plugged in but not charging. The power supply will maintain the charge level (%), but not add to it. Removing and reinserting the battery allows the power supply to add to the % charge to 100%.

Steps performed:

• Turning the computer off and restarting it returns the computer to the Plugged in, Not Charging state.
  
• Removing the battery again allows one complete charge, after which the laptop would no longer charge again.
  
• I have used more than one power supply with the same condition.
  

To resolve the issue, I remove the battery, obtain a complete charge, and maintain this charge by always keeping the power supply plugged in.

What is the root of the problem?

 

Plugged in but battery does not charge

If the laptop works without the battery then charger is functioning correctly. Take a cloth with a bit of rubbing alcohol on it (or some on-the-go alcohol swabs), and clean the metal contacts that connect your battery to your laptop.

Make sure to install all Windows important updates.

Install latest versions of your laptop device drivers you can download the latest device drivers from the device manufacturer or from your laptop manufacturer website.


Step 1

1. Shutdown your laptop.

2. Remove the battery.

3. Connect the AC power adapter to your laptop.

4. Power on the laptop

5. Open the Device Manager by typing Devmgmt.msc into Start Menu or from Control Panel.

6. Under the Batteries category, right-click all of the Microsoft ACPI Compliant Control Method Battery listings, and select Uninstall (it’s ok if you only have 1).





7. Shutdown the laptop.

8. Insert the battery.

9. Power on the laptop.

If above suggestions wont resolve the battery charge issue then follow below steps.




Step 2

1. Shutdown the laptop.

2. Remove the battery.

3. Start the laptop with only AC adapter connected to laptop.

4. When you login to Windows OS connect the battery while Windows OS working.





Step 3

Reset the System Management Controller. Use one of these methods to reset the SMC, which controls battery management, battery status light.

1. Shut down the computer and disconnect the power cord.

2. Remove the battery.

3. Press and hold the power button for ten seconds.

4. Reattach the battery and AC power adapter, then start up the laptop.


Hopefully one of the above suggestions will help you resolve the battery not charging problem. If battery still doesn't charge, you may need to replace your battery.

 

Plugged In, Not Charging

Sometimes depending on your Windows 10 Build, your battery will not charge to 100%, this extends the life of your battery . . . plug out the laptop, drain the battery for 10 - 15 minutes, plug it back in and see if it starts to charge the battery

If however, your battery is not charging at all in Windows 10, follow these steps to rectify this issue:

• Disconnect Power Supply
• Remove battery
• Connect Power Supply
• Turn on the laptop
• Control Panel - Device Manager
• Under the Batteries category, right-click all instances of Microsoft ACPI Compliant Control Method Battery , and Uninstall
• Shutdown
• Disconnect Power Supply
• Insert battery
• Connect Power Supply
• Turn on the laptop

I Hope this Answers your Question!