Windows 10: W11 - my PC went to B&W and will not reset despite 3 tries using Windows ... WHAT IS GOING ON?

Help please!

:)

 

can i reset my pc from the os after downloadind windows 10 from the website

Hi,

Welcome to Microsoft Community.



I understand your inconvenience. We will assist you to resolve this issue.



Yes, you can reset the pc from windows 10 after updating I suggest you to refer the steps given below.

• 
  To go start.
  
• 
  Go to Settings.
  
• 
  Click on Update & security.
  
• 
  Click on Reset this PC.
  
  
  

I suggest you to refer the below link and follow the steps for reset pc and refer the options.

Recovery options in Windows



Hope this information is helpful. For any further assistance on Windows, feel free to post your query on Microsoft Community Forum.

Thank you.

 

How to go about building a tri-boot system?

i dual boot all the time, and going in to tri boot is easy.

step 1) partition the drive in to 3 partitions ( leaving 1 empty for the linux installer. )
step 2) install windows on the first 2 partitions.
step 3) install linux, and let it auto partition the remaining space. ( i recommend at least 30gb of space for linux, because it will make things a lot easier. )

step 4) enjoy.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".