Windows 10: Wake on Lan does not work after shutting down PC via network command from Linux

Hello,


I have a java job that shuts down the PCs in my network every night and should also start them every morning at 7AM via magic pack.

My problem is that WakeOnLan does not work after the PCs are turned of via network.

Command used to turn off PC: net rpc shutdown -f -t 60 -U userName%password -I 192.168.x.x

If i shut down the PC from windows Start -> Shutdown the WakeOnLan works.


Any suggestions on how to fix this?

:)

 

Wake On LAN is Not Working


I have been unable to get Wake on LAN functionality to work in Windows 10:

• I am attempting to do a Wakeup on LAN to my desktop computer which is running Windows 10 from my laptop which is also running Windows 10. The desktop computer is connected to my router through a wired Ethernet connection and the laptop is connected to the same router via a wireless connection
• I'm doing this within my Local Area Network so I'm not going through a router from the external network
• I've upgraded the driver on my network adapter to the latest version
• I've enabled all the required functionality in the BIOS to enable Wake on LAN
• I've turned on all the required settings in my network adapter to enable Wake on LAN
• I've disabled "Fast Startup" in Windows 10
• I'm using the "Wake on LAN" software application from Aquila Technology
• The software is installed on both my desktop and laptop and I've tested it with the desktop in "listening" mode and verified that the desktop receives "magic" wake-up packets when it is up-and-running
• When my desktop system is powered down and I send it a Magic Packet in exactly the same way as I did when it was powered up, nothing happens and it doesn't respond to the wake-up packet

Any suggestions of what I can do to further troubleshoot this problem?

Thanks,

 

Wake on LAN not working

I just cannot get wake on LAN working.
I have it enabled in my BIOS and supposedly my network card supports it as seen in this command.



However when I try to enable it I get bamboozled.



Also, sadly it is grayed out in the device manager.




Could the fact that hyper-V is enabled and has virtual switches be the culprit? I am out of ideas...

Also winver is:

 

Wake On LAN is Not Working

Try a free ware from Nirsoft: WakeMeOnLan - Turn on computers on your network with Wake-on-LAN packet
and run it, you'll get a GUI interface but can also run from the Admin command prompt with switches.

To wake up computer:
WakeMeOnLan.exe /wakeup xx:xx:xx:xx:xx:xx ====> the MAC ID
WakeMeOnLan.exe /wakeup IP ADDRESS
WakeMeOnLan.exe /wakeup COMPUTER NAME

To shut down:
Use Shutdown command as before

WakeMeOnLan GUI