Windows 10: Want to open a New Drive

Hey, in my disk, there is 140 GB free space. But I can't open a new volume. Every time when I want to open a new volume from the disk management and select 'New Simple volume' and click finish from the pop-up, a new pop-up comes and it shows an error message 'There is not enough space available on the disks to complete this operation. I can't bear expenses of third-party application for this. What should I do???

:)

 

Save RAW drive - Don't want data


Open Admin command prompt, then type:

1. diskpart
2. list disk ======> Take note of disk # of the RAW drive
3. select disk # ======> is the number in step 2
4. clean
5. exit

Open Disk Management and initialize it, Create Simple, format.

 

Reinstall Windows 10 to new hard drive

Hi Rodolpho,

We want to know about the issue you're having with your recovery drive. Please answer the questions below:

• Are you trying to reinstall Windows 8 or Windows 10?
• If you already upgraded to Windows 10, were you able to create a new copy of the recovery drive?

We suggest creating a new copy of the recovery drive and then follow the steps provided by Andre Da Costa above this thread.

Update us with the outcome so we can assist you further.

 

How to Partiton a Hard Drive in Vista

This is a way to get Vista to see another hard drive that is not associated with the OS. There is some times when your new hdd doesn't seem to want to work well with Vista. But, there is a solution in it.

Open the Computer Management By doing these steps.

• Click on the Start Button
• Click on Control Panel
• Click Administrative Tools
• Double click on Computer Management

You are now in the Navigation panel of the Computer Management.
When in Computer Management, you then have to allow the new drive to be recognized.

• Double click on Storage
• Double click on Disk Management

Now in the middle of your screen there is the layout of the Disk Drives that you have. The drives that are partitioned will show by the drive lettering. The others will just show up as having nothing at all in them. Below that there will be the Disk drives that are installed into the computer. You'll see that the primary one will all ways read as "Disk 0". Then you will have Disk 1 and so on. Under the Disks there will also see your CD-Rom drives.. If there is more then one, it will be labeled the same as Disk drives..

On to the Partitioning of the drive in question.

• Right Click on the drive
• Click to format the drive or Enable Volume. There will be a series of windows that open up. This is Vista's formatting. Just go threw the windows, and make sure everything is the way you want it to happen.
• Once the formatting is done, will take some time depending on the drive size.
• Right click on the drive
• Click on Mark the Partition as Active

After you have done those steps, The drive will be up and running threw Vista.



:Side Notes:
If you are not the Administer to the Os, then you will have to enable it..
You may also want to redo the drive lettering of it all. But, I really don't see a reason to do so. If you do, you have to redo drive paths and so forth.. A lot of work on something so small...