Windows 10: Watchdog code after update

Hello I downloaded an update and my computer kept looping through start and a Watchdog code and wouldn't start properly I followed the instructions for a blue screen error and I phoned the 1800 number on the internet for Microsoft help and they wanted to charge me $229 for some protection that will stop whoever has access from using my IP address, I have trend Maximum security and have scanned my computer with no issues I still have the update pending on my start up and don't really know what to do as I am not really a computer savvy person. I don't know how to tell if the person helping me is

:)

 

DPC Watchdog Error

Hi,

DPC Watchdog Violation (error code: DPC_Watchdog_Violation) is a common issue in the Windows operating system. It's occurred due to some specific reasons, like unsupported SSD firmware, old SSD driver version, hardware incompatibility
issues, or system files are corrupted. To isolate this concern, kindly answer the following:

• Any changes made on the computer prior to this concern?

• What troubleshooting steps have you tried so
  far?
  

 

Windows watchdog blue screen

Hi Teemu,

This error can be caused most likely by an outdated driver for one of your hardware components. DPC stands for Deferred Procedure Call. The blue screen error code indicates that watchdog detects a DPC running too long, which stops your process to avoid data
corruption or damaging the computer. To help resolve the issue, we suggest
updating all the drivers on your PC as an initial troubleshooting step.

If the issue persists, you can perform a disk check. Follow the steps below to know how:

• On the search bar, type cmd then choose Command prompt.
• Right-click on it and select Run as administrator. Click
  Yes to continue after administrator permission was asked.
• Then type chkdsk /f /r and press Enter to start the process.
  

Note: Disk check will start the next time you boot your PC and it might take some time to complete.

After doing the suggested steps, check if the same issue will occur.

Feel free to post back if you need further help.

 

Stopcode DPC Watchdog Violation

In most cases, the DPC Watchdog Violation error occurs because something goes wrong with the firmware of solid state drive.

However, some cases, corrupted Windows updates are also caused this problem.

Check out this guide.

Bagaimana Memperbaiki Kesalahan Pelanggaran DPC Watchdog Di Windows -