Windows 10: WATCHDOG ERROR CODE

Getting a blue screen upon start up of my PC at least 5 times before it lets me log in and use it just fine. I have windows 10

:)

 

DPC Watchdog Error

Hi,

DPC Watchdog Violation (error code: DPC_Watchdog_Violation) is a common issue in the Windows operating system. It's occurred due to some specific reasons, like unsupported SSD firmware, old SSD driver version, hardware incompatibility
issues, or system files are corrupted. To isolate this concern, kindly answer the following:

• Any changes made on the computer prior to this concern?

• What troubleshooting steps have you tried so
  far?
  

 

BIOS error codes

So I have motherboard with installed small LED screen, which presents BIOS error codes.

Where can I find a list of those errors. And I don't mean beep codes, but the "number" codes.

Ex after installing sound card, the motherboard startup fails with the code 15.

Example picture of code is here.

 

Windows watchdog blue screen

Hi Teemu,

This error can be caused most likely by an outdated driver for one of your hardware components. DPC stands for Deferred Procedure Call. The blue screen error code indicates that watchdog detects a DPC running too long, which stops your process to avoid data
corruption or damaging the computer. To help resolve the issue, we suggest
updating all the drivers on your PC as an initial troubleshooting step.

If the issue persists, you can perform a disk check. Follow the steps below to know how:

• On the search bar, type cmd then choose Command prompt.
• Right-click on it and select Run as administrator. Click
  Yes to continue after administrator permission was asked.
• Then type chkdsk /f /r and press Enter to start the process.
  

Note: Disk check will start the next time you boot your PC and it might take some time to complete.

After doing the suggested steps, check if the same issue will occur.

Feel free to post back if you need further help.