Windows 10: We can’t find the Printer, Error 1801, The printer name is invalid

​

We have noticed that on some occasions, a Windows device fails to connect to the Printer’s network. When trying to connect to the network, Windows gives the following error message. We can’t find the printer you’re trying to install. Check to see if the printer was renamed and try to install again or contact your […]

This article We can’t find the Printer, Error 1801, The printer name is invalid first appeared on TheWindowsClub.com.

read more...

 

Can't share printer—getting error message

Step 1: Go to store.
Step 2: Buy a less shitty printer.
Step 3: Pick up some beer while you are there.
Step 4: Enjoy both your new printer and your beer.

In all seriousness, I have had more issues with Lexmark printers and their shitty drivers then any other manufacturer, HP is a close second though.

However, if you don't want to get a new printer*Laugh :laugh:, and I can understand that, when my Lexmark was giving me the same troubles in Win7(and Vista) I had to make sure the Windows firewall was ON and the firewall service was enabled and running. After I shared it I could re-disable the firewall and firewall services.

 

Can't share printer—getting error message

Not working... I see the printer, but when I go to add it, I get this messge: "Windows could not connect to the printer (error 0x0000000d)."

I installed the 32-bit drivers for it and printed something out from the pc the printer is connected to, and I went to the additional drivers page and added drivers for 64-bit, and when I went to add the printer on the other machine, it copied drivers over, but after that I got the error message listed above...

 

printer won't work on network but will over usb

his printer has a built-in print server.

What you need to know what ip is being give to the printer. Perhaps you can print a status sheet from the printer.

Then Go to printers in control panel

add a new printer

local printer attached, uncheck automatically detect and install PnP printer

create a new port, select standard tcp/ip port

a new window should open and enter the ip there where it says printer name or IP address (port name then should be also be filled as you go)

and pretty much follow the rest of the steps, you will need to install the printer drivers.


These steps is the easy, but not the right way.

The right way is to use the network option on the initial screw and search for the printer server...but that can be tricky to configure.