Windows 10: We couldn't install win 10

We have your pc back to the way it was right before you started installing windows 100xC1900101 - 0x400DThe installation failed in the first boot phase with an error during migrate data operation

:)

 

"We couldn`t create a new partition or locate an existing one."

Try this:

Before you get to that message, press SHIFT + F10 to open a command prompt.

Run diskpart.
At the diskpart prompt, run these commands:

list disk

At this point you should see the SSD as disk 0. If it has another disk number, use that number rather than "0" in the next command.

select disk 0
clean
exit (to exit from diskpart)
exit (to exit from the command prompt)





That should clear the contents of the disk. The entire disk space should then show up in Windows setup as "Unallocated Space" as in the screenshot below.

 

Couldn´t install SBSH Explore Pro- installation failed after download

I couldn´t install "SBSH FExplorer Pro" from Nokia Store (cost 4,99 EUR).

Installation failed after download.

Allow all software for installation is active, Online certificate check: On,

download and install is on C:, Space on C: is over 200 MB available.



E72-1, Typ RM-530

software version 053.001, special version 053.001.231.03

Updates for this firmware version available: None.



Freeware of SBSH Explore works perfect- Pro Version installation failed.

After download I couldn´t find installation data (zip or .sisx) on C to with freeware version..



Somebody for help or any ideas?



Support speeches: German and English.



Thank you!





Support of SBSH was contacted.

 

"We couldn`t create a new partition or locate an existing one."

Same as over here:

Error message: "We couldn`t create a new partition or locate an existing one." | Windows 10 Forums