Windows 10: We’re updating Settings. It should be ready to use again shortly.

Just shows up when I try to open settings

:)

 

Intel Readies P55 Chipset B3 Stepping Update

Intel's is readying a hardware update for its P55 Express chipset, currently the only core-logic for the company's brand new socket LGA-1156 processor platform. The new B3 stepping of the P55 PCH will bring with it a little more than new MM number and S-spec numbers. A list of changes is as follows:

• New MM number and S-spec numbers for the converted products;
• Firmware and minor BIOS updates are required with the conversion;
• Processor MRC/microcode update required to enable future processors;
• Recommended storage driver upgrade from Intel MSM 8.9 to Intel RST 9.5.

Although it is listed that the MRC update enables 'future processors', Intel, in a statement issued to X-bit labs assured that the current B2 stepping of the chipset (found on current socket LGA-1156 motherboards) does not leave out support for any of Intel's new LGA-1156 processors that are slated for release in the very near future. The dual-core "Clarkale" 32 nm processor will be supported by both B2 and B3 steppings of the chipset.

P55 B3 stepping is pin-identical to P55 B2, and hence motherboard vendors will not have to come up with new designs. Sampling of the new stepping began as early as on October 02, 2009, and it is scheduled for shipment to manufacturers by the 7th of December, 2009. P55 is the performance core-logic for the LGA-1156 platform. It supports Core i5 and Core i7 "Lynnfield" processors with discrete graphics.

Source: X-bit labs

 

Windows 10 Defender - Cannot open, I get a message "Give us a minute. We’re updating Windows Security. It should be ready to use again shortly."

On my laptop I have two users. The administrator user can open Windows Defender but the other user always gets the message "Give us a minute. We’re updating Windows Security. It should be ready to use again shortly."

Till now I've tried:

• SFC /scannow
• Dism /Online /Cleanup-Image /StartComponentCleanup
• Dism /Online /Cleanup-Image /RestoreHealth
• Windows Update troubleshooter

None of these reported any problem.

I am on Vesion 2004, build 19041.450.

Any suggestions?

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.