Windows 10: what does "REAGENTC.EXE: Operation failed: b7" mean?

I was attempting to enable 'reagentc' in order to reset my PC when I encountered this error message:makefileCopy codeREAGENTC.EXE: Operation failed: b7REAGENTC.EXE: An error has occurred.I have searched extensively, but I'm unsure about what I might be doing wrong here. Thanks for your assistance."

:)

 

ReagentC "operation failed: 32"

Hello.

What, exactly, does "operation failed: 32" mean when it comes from ReagentC?

Is their a published list of all of the ReagentC failure numbers, and what they mean or what triggers them?

 

Cant' Create the recovery drive - and when trying to enable reagentc, I get: REAGENTC.EXE: Operation failed: b7

Thank you. It's disabled, and I cannot enable it, I get error B7. I have already used reagent /setreimage, and that solved my previous error message, but now I am getting error b7.

And thanks I will go to a larger drive soon.

 

Reagentc failed

I was in the same situation but I had a hard time to set the path; eg: reagentc /setreimage /path D:\Recovery\WindowsRE

It wouldn't let me. I had to do the following inside DISKPART (Using your snapshot for the syntax):
- "select disk 0"
- "select volume 0" (your partition listed #1 as the Recovery)
- "assign letter = D"
Note: commands without double quote

After above steps, "reagentc /setreimage /path D:\Recovery\WindowsRE" will work.

The file ReAgent.xml under C:\Windows\System32\Recovery will be updated (if you made a backup prior, you will notice the updated timestamp)

Another way instead of using Drive letter, syntax is as follow:

"reagentc /setreimage /path \\?\GLOBALROOT\device\harddisk0\partition1\Recovery\WindowsRE"
(note the bolded variable that matches the information from DISKPART)

When REAGENTC.EXE: Operation Successful. Windows RE status will always be disabled still.

In order to enable Windows RE status, you need to reboot into the Bios then turn off Legacy Bios in CSM and Secure Boot will automatically pickup the Windows EFI System Partition. Save the Bios and boot into Windows.

Once started, Windows RE status will be Enabled automatically. No need to enable it.

In System Information Bios Mode will be UEFI.

Hope this explain a bit more of the final step as I was struggling why I couldn't enable the RE status when "reagentc /setreimage /path D:\Recovery\WindowsRE" was successfully completed.

Good luck!