Windows 10: What happens if I plug in a second M.2

I currently have a ASRock B450 Pro4 motherboard and a Crucial MX500 M.2 ssd. I just bought a WD Black SN750 NVMe and was wondering if I could even plug it into the Ultra M.2 slot on my motherboard and what would happen if I had both of the ssd's in at the same time.

:)

 

M.2 SSD not being able to boot from it, windows doesn't recognise.

Ok, this is what happened after all the comments and suggestions, @dude: Thanx for the video, my mb had non e of those settings, it had the raid/option memory gene or achi. Can only choose one or the other. @Saltgrass, my settings did point out auto and enabled the pcie x4, gen 3. I did an bios flash as suggested, because my bios was not the latest version, after a reformat the m.2 was picked up, still cant install OS onto it as it states legacy not found, removed my dvd rom from the sata port to another, and the drive was found and installed. Only issue now is that it's still not my OS drive but it at least now works and is installed, but on the Intel rst drive the obtain memory gene option to enable is greyed out, and shows as disabled. However the program lists the M.2 and it is working 100%,. I installed overwhatch onto it, it performs perfectly. But will update the intel driver tonight and see if that makes any difference. Seems the bios flash enabled the settings listed by @dude that was not present pre-flash.

So the m.2 drive works. I can game off it and install omnto it. Can not install windows on it, gene memmory is enabled, pcie x4 is on and on auto detect, Motherbaord lists all the drives connected, motherboard ahs been updated to latest bios. After flash new settings became available, m.2 is now on memmory gene enabled not achi, windows os is enabled and fast boost is enabled, intel rst is installed and lists all the ssds and the m.2, however the m.2 on memmory gene is dissabled and the option to enable is greyed out. Will update the driver as Essenbe suggested of the m.2 and see if anything changes. Thank you all for the help, I can now atleast use my m.2

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

PCIE to M.2 adapter.

Thanks @cadaveca. M.2 in raid, wonder what the benefits are.

So any suggestions on a better adapter?