Windows 10: What Is This New Screen I See When Booting Or Restarting?

I don't know what I did, but why do I see this screen the last three times I've booted up or restarted?I have to hit F1, then restart from there, hope nothing's too messed up!

:)

 

No BIOS screen on boot

Situation:

Have recently redone water cooling loop. System has been running fine for the last 5 days. This morning I was trying to tidy up cabling and then booted it again to make sure it still worked and everything was connected.

The login prompt was on the screen, but I didn't have the keyboard there yet. About 15 minutes later I came back with keyboard and mouse from my other computer and it was off. Then I realized that the fan for the NB/IOH was not plugged in, and that it most likely was the reason it had turned off. Although I have not had a fan there longer than that, it does go up to 90C or more without one after a while.

Now each power on results in a fans an pump starting an leds on the MB, followed a power off and restart with no video on monitor at all. Can't get it to do anything else.

Steps tried already:

Reset BIOS by setting jumpers.
Reset BIOS by removing battery.
Remvoed ram and left one stick in.
Tried one stick of alternate ram.
Checked PSU with tester.

PSU looks ok and nothing else gets it past the blank screen. Always restarts again after I power it on.

Thanks for any suggestions.

 

Computer randomly has black screen and restarts

Taco this could be software also. Before you get all crazy, do as Erocker suggested. Find out the error in the Event Viewer. Look for the faulting module and the error code itself. Also check the reliability monitor. At the bottom it will have "View all Error Reports". Post a screen of whats in there if anything.

This could be a simple as a bad driver install.

ALSO have you downloaded or installed anything lately? STAY OUT OF THE DAMN BIOS UNTIL WE KNOW THE ERROR! lol. I know you. Baby steps boy, baby steps.

 

PC shows Automatic Repair screen after booting

Hi,

Thank you for replying.

Refer the steps mentioned below to restart the computer in Safe Mode:

1. On the Choose an option screen, click on Troubleshoot.
2. Click on Advanced options.
3. Click on StartupSettings and click on
   Restart.
4. After the device restarts, you will see list of options. Select option
   5 or press F5 to boot the computer into
   Safe Mode with Networking.
   

After restarting the computer in Safe mode, refer the steps mentioned in my earlier response to perform clean boot and see if the PC boots normally.

If the computer doesn't boot,
I would also suggest you to refer the troubleshooting steps mentioned in the section
Use installation media to restore your PC from the article
Recovery options in Windows 10.

Let us know how it goes.

Regards,

Nikhar Khare

Microsoft Community - Moderator