Windows 10: What to do when I'm stuck at 4% while I reseted it and I waited 30min

I'm stuck at 4% with my hp pavilion g6 when I performed a reset so I went biking for 20-30minBut it still was at 4%

:)

 

What to do when I'm stuck at 4% while I reseted it and I waited 30min

I'm stuck at 4% with my hp pavilion g6 when I performed a reset so I went biking for 20-30min

But it still was at 4%

 

Windows 10 very slow boot - stuck at the logo screen for over 30mins

It seems that you have a raid configuration over multiple Western Digital disks.
the boot trace shows that the delay is probably caused by the amd_xata.sys driver. This driver is outdated (2015).

Update this driver as a first step.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".