Windows 10: When booting up my PC, it will black screen, it will then automatically go into the BIOS...

Recently my PC froze and crashed. When turning it back on windows wont boot, and will only go into the BIOS. no settings in the BIOS have been changed, and they are all the original settings. When i leave the BIOS, it will attempt to boot, however around 3-5 seconds later my BIOS will load up.MB: MAG B660 Tomahawk WIFI DDR4CPU: 12th gen i9-12900RAM: 2x Corsair DDR4 Vengeance RGB pro16GB Graphics card: MSI Nvidia Geforce RTX 3070 Ventus 3X plusStorage: both a hard drive and a SSDWhat I have attempted to fix the issue:- Drain the CMOS battery- Checked hardware connections- Attempted Windows Sta

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

Desktop PC boots to black screen after ASUS BIOS update

I updated my BIOS as a last resort to fixing my system reserved ram. I ended up getting the infinite black screen. I followed the steps above, shutting down my PC, unplugging my PSU, taking the battery from MOBO, and changed the display ports to MOBO. It didn't quite work yet still left with this black screen death. I repeated those steps one more time but removed my ram and changed them to dimm slots 2 and 4 instead of 1 and 3. For some reason it fixed everything. Now I have all my ram minus 566MB reserved.

 

Desktop PC boots to black screen after ASUS BIOS update

After searching around Google, I came upon a post where somebody experienced a similar issue and managed to fix it by simply doing the following:

1. Force the PC to shut down
   
2. Unplug the power cord from the PSU for 20-30 seconds; enough so that there's no dormant power left over
   
3. For good measure, if your motherboard/CPU has embedded graphics, temporarily connect your monitor to that instead of your GPU
   
4. Plug the power cord back in and then boot the system
   

Some notes:

• This is strictly for desktop PCs (not laptops). If you're on a laptop,
  you might need to disconnect both the power adapter and the battery
  to completely shut it down
  
• If your system was not bricked because of the BIOS update, you should see a
  message on the screen stating that the BIOS update is resuming, and
  that you should not cut the power to the PC
  
• If the BIOS update was successful, your PC will restart again to a
  vanilla POST screen (not the splash screen) and you will need to
  press F1 here and to set everything in the BIOS back to your own
  
  preferences again
  
• From what I can tell, the BIOS update did succeed after the
  
  flash in the BIOS, but the installation simply glitched out and
  failed to complete the remaining steps after restarting
  

Some things I should've done before I updated my BIOS:

• Saved a copy of my BIOS configurations to a .CMO file in a USB drive
  
• Reset my BIOS settings to default before the update