Windows 10: When i boot up my PC i am brought to this screen. I've tried almost everything and it just...

submitted by /u/DerpyBird39
[link] [comments]

:)

 

hd6950 to hd 6970

ok
i ve tried everything:with atiflash from dos,winflash.step by step with bios powercolor hd 6970 from the database.
nothing,doesn´t work.any suggestion????

 

How to go about building a tri-boot system?

i dual boot all the time, and going in to tri boot is easy.

step 1) partition the drive in to 3 partitions ( leaving 1 empty for the linux installer. )
step 2) install windows on the first 2 partitions.
step 3) install linux, and let it auto partition the remaining space. ( i recommend at least 30gb of space for linux, because it will make things a lot easier. )

step 4) enjoy.

 

PC shows Automatic Repair screen after booting

Hi,

Thank you for replying.

Refer the steps mentioned below to restart the computer in Safe Mode:

1. On the Choose an option screen, click on Troubleshoot.
2. Click on Advanced options.
3. Click on StartupSettings and click on
   Restart.
4. After the device restarts, you will see list of options. Select option
   5 or press F5 to boot the computer into
   Safe Mode with Networking.
   

After restarting the computer in Safe mode, refer the steps mentioned in my earlier response to perform clean boot and see if the PC boots normally.

If the computer doesn't boot,
I would also suggest you to refer the troubleshooting steps mentioned in the section
Use installation media to restore your PC from the article
Recovery options in Windows 10.

Let us know how it goes.

Regards,

Nikhar Khare

Microsoft Community - Moderator