Windows 10: When I plugged in my ethernet cord to my windows 11 pc nothing happened.

I checked everything on the outside I think but nothing happening when I plug in my ethernet cord.

:)

 

my ethernet cord

I've tried several ethernet cords and still cannot get a connection. I tried rebooting the router and that didn't work either. I'm afraid something is wrong with the place you plug the cord into the laptop. What can I do to fix it?

 

Cellular Connection not working while Ethernet cord is plugged in.

As shown below I have two networks. One one the left is cellular connection to the left, that gets me out to the internet. The one on the right is a closed network. It does not have access to the internet, only IP devices. And the closed network is a
point to point connection with no gateway.

Problem: Cellular connection works fine, gets me to the internet until I plug in the Ethernet cord. As soon as plug in the Ethernet cord, Windows is trying to send all my internet traffic out the Ethernet port, but of course it is a closed network with
no access to the Internet. Basically it does not allow me to get to the internet unless I unplug the Ethernet cord.

I have tried changing the interface metrics, but that seems to do nothing at all. I was thinking about using the route command to add static routes, but the Point to Point Ethernet connection has no gateway because it is a point to point connection.

Any help would be greatly appreciated.

 

Cannot connect to ethernet no valid ip configuration

We appreciate the information you've provided. We'd like to confirm the results after following the steps on the link provided on our previous post.

Meanwhile, to isolate your concern, we suggest that you check the following:

• 
  If the Ethernet port is clean.
  
• 
  If the end of RJ45 (Ethernet cord) is still intact.
  
• 
  If available, test the RJ45 (Ethernet cord) to your other device and check if issue persists.
  

We look forward to your reply so we can assist you further.