Windows 10: When I start the laptop but the Windows unlock image does not load

When I start the laptop, the laptop logo loads, but the Windows unlock image does not load, the face detector works and the laptop unlocks, but there is no image, only when I close it and open it again, I can see everything. Can you help me?

:)

 

Unlocked Realtek HD Audio Drivers Windows 7 & 8 (With Dolby Digital Live and DTS Interactive)

DTS supported natively by Windows 8/8.1 and it should work on windows 10 too just DDL require to unlock your driver .

 

Custom Windows 10 Setup Image Background

I found the solution, after ~8 hours of trying.

The solution is as follows (also working with 20H2):

1. Extract / Flash the Windows ISO File
2. Temporary copy "boot.wim" to a place of choice
3. Mount "boot.wim" with gimagex (Select the 2nd image - there are two images in boot.wim)
4. Delete "boot.wim\sources\background.bmp" with Unlocker, then add your own with the same resolution (bmp, 24bit)
5. Delete "boot.wim\Windows\System32\setup.bmp" with Unlocker, then add your own with the same resolution (bmp, 24bit)
6. Copy "boot.wim\sources\spwizimg.dll" to somewhere temporary and replace the bmp source file (517 : 1033) with Rescource Hacker, then remove the original one with Unlocker and paste your modified one in the sources folder
7. Now unmount the image with gimagex by checking the CheckBox "Commit Changes" and then press Unmount
8. Copy the modified "boot.wim" back to the Flashed / Extracted Windows ISO File

Here is a tutorial I found with the exact steps:
Attention: Follow every step carefully!

Many Greetings

 

System Image Problem

Hi Nick,

No need to stress.
Since the dl of the windows install media failed twice in a row already we are going to do as Bill suggests.
No use wasting another day on it at this point.

Here is a description of the steps to follow:

- Connect the external drive that contains the Macrium images we made.

-Boot off of the Macrium rescue CD. Make the necessary changes in bios so booting from CD is the highest on the boot order priority list or use the machine's bootmenu (Fn key ? ) to select to boot off of CD.

- From within Macrium select restore. Browse for image 0_SysRes etc. and load it in Macrium.

- Select the drive to restore to: your c: drive. Make sure it is the correct drive. Only one internal drive should be connected at this point.

-Drag and drop the loaded backup image to the beginning of the C:\ partition. It must be fully at the left of the partition.

- Click restore and confirm.

- Once it has finished close Macrium. It will automatically reboot.

-Boot again off of the CD.

-Macrium loads and select restore again.

-Browse for and select 1_Windows from the backup drive. Select the same destination drive and drag and drop it right next to the small partition we just restored. Click restore, confirm the overwrite and let it finish.

-Again close Macrium and reboot once more off of the cd.

-In Macrium on the top left hand side there a menu option that reads something along these lines (I'll load it in a few minutes to verify and correct if necessary) : "Fix Windows boot problems".
Click it.

-Let it finish and reboot off the main hard drive this time.

- Cross your fingers and hopefully Windows will start up.


I suggest not doing this immediately. I hope Bill will have a look at the suggested steps and correct any if need be.

Best, *Wink