Windows 10: When launching games, pc screen goes black and pc reboots 2ish minutes after, with event...

Been having this problem for about a week now, that being whenever i boot a graphically intensive game, the pc screen goes black and eventually the pc resets. I've gotten my pc to work twice for a day and 2 days respectivly. The first time was by repairing windows this one im unsure, i was doing multiple fixes at once and the second time i moved my gpu from the top pci slot to the bottom one, which lasted 2 days before the problem resolved. Another thing to note is i was never able to overclock my room to its rated clock 3600mhz, despite the fact that both my motherboard and ram were brand

:)

 

Computer flickers to black screen then blue screens when launching games

When I launch majority of games on my computer, the game launches for a second or two before both of my monitors turn black and flash on and off briefly showing my desktop before my computer eventually blue screens after a few minutes. I have tried installing new graphics drivers however i have the same problem. There are a few games that run perfectly with no problem, however the majority just crash my pc.

When blue screened, I am given the stop code as

“Stop code: DRIVER POWER STATE FAILURE”

Looking at event viewer, Kernel-power, with event id 41 and task category (63) is shown as the reason for the critical event.

any suggestions on what to do to solve this issue,

thanks

 

Artifacts on screen. Screen goes black

Got a new pre-built pc. I think the gpu could be defective. Artifacts on screen (pixels, symbols, lines) White pixels on screen in bios and in windows there is 2 vertical lines 2ish inches wide with varying colors in them.
I figured before i send the gpu in i would troubleshoot a bit. I performed a clean install of windows 10 Pro x64. It was running fine for a bit then the screen went black. If i reboot the windows loading screen shows with the circle of dots then the screen goes black before sign - in. I can boot into safe mode (thanks @Brink for the tutorial on adding safe boot with bcdedit). I updated graphics drivers to no avail. I tried updating "all - in - one" drivers from AsRock but cant install them because they aren't signed. I booted with digital signatures temporarily disabled but still get the same error when attempting to install drivers. I made a restore point immediately after the clean install, every time i load it, windows works for a couple minutes then screen goes black. I tried updating windows and it gets about halfway through then screen goes black. I tried setting resolution to 800x600 but screen still goes black. This is a no mouse cursor black screen btw.

I'm going to try a few things now and will update this post with any new info.

Thanks in advance

 

pc turns in and goes to a black screen