Windows 10: Where can I go to install the latest version of the Mobile 5th Generation IntelR CoreTM USB...

I am trying to re-install my drivers with the latest versions, and the driver updater tells me that that there may be better drivers on the device manufacturer’s website.

:)

 

Generic superspeed usb hub error after 1809 update

Hi CerenDemirci,

Thank you for writing to Microsoft Community Forums.

• Can you access the USB from Windows explorer?
  

Windows has stopped this device because it has reported problems. (Code 43), this error is an indication of corrupted loaded drivers. By default, Device Manager only displays drivers of
connected devices, sometimes windows can get "confused" with the old drivers in the system. I suggest you to follow the steps mentioned below and let us know if it is fixed.

Method 1: Install Generic driver.

1. Connect one of the USB hubs.
2. Press Windows and
   R key together on your Keyboard.
3. Type devmgmt.msc and hit enter.
   
4. Right click on the Generic super speed USB hub.
   
5. Click on Update Driver.
6. Click on Browse my computer.
7. Select Browse, navigate to: C:\Windows\winsxs when it asks for the driver location.
   
8. Click on Install to install the Windows generic file.
   

Method 2: Uninstall and reinstall Driver.


I would suggest you to follow the steps
provide by Aswin_Ananad on 6th April 2016. For more information, check the Microsoft article on
USB Device not recognized.
Let us know if you need further assistance regarding this issue.

Hope it helps.

Roohi Taj S

Microsoft Community - Moderator

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

Installing generic printer usb port not showing

It sounds like the printer's own software has not been installed if it's still listed as an Unknown USB device in Device Manager.

Did you go to the manufacturer's Support Downloads web page to download and install the latest printer software?

Normally the USB should be unplugged during the installation of the software until it prompts to plug it in. This is to keep Windows from auto-installing it's own software that might interfere. That's the reason I gave the steps to clean out any existing drivers
since these are the cause of most problems.