Windows 10: where can I reset my smtp settings

My email is not working because my SMTP setting says it is not connected - I have done nothing to cause this except updated from Microsoft 10 recently?

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

setting for smtp is incorrect

This is not really a good forum for this (since this is a forum for
Windows Phone).



Here are the settings though:

• "POP server" – Set the incoming server as pop3.live.com and incoming port as
  995.
• "POP SSL required” – Yes
• "User name" – Specify your Windows Live ID including the domain name. This is usually the Hotmail full email address. For example,
  L: yourname@hotmail.com
• "Password" – Specify the password to your Windows Live or Hotmail Account.
  
• "SMTP server" – Set the outgoing server as smtp.live.com and the outgoing port as
  25. You can use 587 as the SMTP port if the default port is blocked for some reason.
  
• "Authentication required" – Yes (Note that this authenticates the POP user name and password. i.e. the user name and password of your Windows Live Hotmail Account).
• "TLS/SSL required" – Yes

In most email clients “Authentication required” is turned off by default. You must make sure to enable it. You must also make sure that SSL is enabled for POP and SMTP connection.